Random good picture Not show

(31) The minimum power loss theory is used for obtaining the variety curve description of the clearance and the distance away from the injection gate.

(32) In the end, to lower the power loss on MOSFET, another optimizing principle based on the selection of superior load curve of MOSFET was proposed.

(33) Then the constitution, cause, theoretical calculation method of power loss and the coil temperature rise characteristic are analyzed.

(34) The self-adaptive reclosure, which is aimed to distinguish the transient fault and the permanent fault, can reduce the power loss caused by faults and enhance the stability of power system.

(35) Objective introduced in this paper is active power loss minimization and movement minimization of control element, and at the same time SCOPE software is used as a computing tool.

(36) By using the fast switch, the power loss of the FCL in normal operation condition could be avoided, and by using the GTO, the rapid current-transferring could be realized with a smaller difficulty.

(37) Currently, improving voltage quality and saving power loss have been job emphasis of power companies.

(38) To have power loss analysis is very important for designing and optimizing the circuits.

(39) The no load power loss of the plate friction clutch in disengagement affects the transmission efficiency, the heat value and the life of the firection plates.

(40) Coalification oxygen did not take over the station, oxygen production has been the use of mechanical compression air separation oxygen, power loss and annual maintenance cost of large equipment.

(41) Idle is rough, and high - speed miss and power loss may result.

(42) But there is also escapable and unreasonable part in power loss. Therefore, how to reduce power loss to its minimum level so as to realize maximal economic benefit is the aim of power loss analysis.

(42) Sentencedict.com is a sentence dictionary, on which you can find nice sentences for a large number of words.

(43) DD862 single phase watt-hour meter is an induction meter which is applicable to measure the rated frequency of 50 Hz , and power loss of single-phase intercourse grid.

(44) The complex method is applied to the optimum design in which the total power loss per unit load capacity is regarded as an objective function.

(45) Reactive power optimization and reactive power compensation in electric power systems are the efficacious means to elevate operation voltage, reduce power loss, and increase the stability level.

(46) Forward Voltage Drop Power Loss, High Efficiency, High Surge Current Capability.

(47) The dynamic model focuses on the mechanical analysis of the swash plate and the shaft, analyzing the power loss.

(48) A weighted average objective function with voltage balance index and power loss is established.

(49) This software has functions of graphic editing, network topological analysis, power information database management, power flow calculating, power loss and reactive power optimization analysis.

(50) Low-power switching power has characteristic of Low Power Loss, high rate of conversion, small size and light weight.

(51) This paper is to introduce the application of Tektronix TDS7000 Digital Fluorescent Oscillometer in measuring and analyzing the power loss of switching supply.

(52) With MOSFETS soft-switched, the switching power loss of MOSFETS, the ohmic loss and the iron loss of coupler core was reduced. It had large importance to improve the whole efficiency for the system.

(53) The ratio of the average power loss to the power loss under peak loading.

(54) The tertiary voltage control module gives the reference voltage curves of the pilot nodes by a power loss least based optimal power flow (OPF) calculation.

(55) We have calculated plasma density distribution, temperature distribution, impurity radiation power loss in SOL with friction.